During the attach phase, a number of checks are performed and the core is configured. -- In progress
- If the 802.11 Core Revision is 4
- Use G PHY Available and A PHY Available (0x30000) as the set flags in the comparison below
- If the 802.11 Core Revision is 5 or greater
Use the current value of the TM State High flags in the comparison below
- Otherwise
- No flags are set in the comparison below
- If the current band is 5GHz and neither bit 0x80000 or the A PHY Available flag (0xA0000) are set
- Can't attach
- If this is the first PHY we're attaching or bit 0x80000 is set
- If the current band is 2GHz and the G PHY Available flag is set
Core Reset and set the G Mode enabled flag (in TM State Low
- Otherwise
- Core Reset with no additional flags
Enable the Analog Core
If the Radio (check the Radio Version Register) doesn't match with the radio version from the table below
- Can't attach
- If this is an A or G PHY
- Generate the TSSI Tables
- If the current band is 2GHz and the G PHY Available flag is set
- Otherwise
- Core Reset with the saved core flags
PHY Type |
Supported Radio |
A |
0x2060 |
G |
0x2050 |
N |
0x2055, 0x2056 |
LP |
0x2062, 0x2063? |